The heavy duty is capable of 5ips print speed using its bit RISC microprocessor. Printer finds the first label gap when print head is closed. Step 4 is automatically repeated. The other end of the cable connects to a serial port on the host computer. To print label the head latch must be closed. The following information is now back to defaults: Mouse over to zoom in.

Uploader: Yolmaran
Date Added: 3 September 2011
File Size: 17.52 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 17400
Price: Free* [*Free Regsitration Required]

Send the file, KBD. Then install the ribbon: Be cautioned that this will reset all printer qrgox back to defaults; if possible, print the configuration label in advance before reset.

Check the active printer driver, and see if Seagull Driver for your Windows system and argxo label printer has been selected. Thermal Transfer printing requires media to print with appropriate ribbon. Remove the outside media guide. Counter-clockwise rotate the screw a half circle and test printing; observe whether the printing quality has been gradually improved or not; and stop the adjustment if the quality is improved.


For unstable ribbon roll rotation, check the label path and make sure the head latch is securely closed. Remove the top cover on both argix and right sides. Refer to the following command sample. During turning the Cam of cutter, release the blade from paper and them remove the paper from the cutter. Detailed Seller Ratings information is unavailable when there’re less than 10 ratings.

Ribbon roll — max OD: The adjusting portions for two hex socket screw locks marked in Fig. Press and hold the FEED button while turning on the power.

ARGOX X-3200

The other end of the parallel interface cable connects to the printer connector at the host computer. After driver installation is complete, click “Close”. d

If the printer supports Argkx, and you have successfully connected it using a USB cable, then the Windows Add Hardware Wizard will automatically detect the printer and display a dialog that allows you to install a driver.


Making a Keyboard Form 1. Table of contents Table Of Contents Manual calibration is needed. Risk of explosion if battery is replaced by an incorrect type.

For the XVL, ignore this step. Figure 1 1 2.

Argox X |

The sample steps below are based on ribbon wound ink-side in as an example. For the XVL model, ignore this step. Insert the left side of dispenser bracket and secure the three screws to the TPH module. Put the media end on the roller. An internal RTC lets you print time and dates on labels.

Argox X-3200 Manuals

Figure 2 2 Print Head Module 3. Clean the roller after it has been in contact with foreign materials argpx as dust or adhesives. Windows XP and higher.

Windows ServerR2,R2, and The printer feeds inches of blank labels. After the adjustment above, ribbon wound ink-side out can be used.